, ,

Sys-Pro 0-10V DIM stand by lighting mode IR Motion Sensor,Recessed

ISOLED
Saadavus:

Laos


Sys-Pro RF/Switch/0-10V PIR built-in motion detector with stand-by light mode, 230V AC, 900 VA

49,00 

Hind KM-ta:40.16 €

1 laos

This built-in motion sensor is suitable for system ceilings, or ceilings with sufficient installation space. The PIR sensor works with infrared as a control signal. The switch-on time is adjustable from 10 seconds to 15 minutes. In addition, a switch-on threshold can also be set between 3 and 2000 Lux.

The sensor detects when a heat source is moving at a speed of 0.6 to 1.5 m / s. When the heat is no longer detected and some time (adjustable) has passed, the sensor switches the lighting off again.

Features
• Detects 360 °
• Switching capacity of up to 300 Watt
• IP20
• 5 years warranty

Properties
» Ceiling installation PIR motion detector, recessed daylight sensor.
» Output 1 channel 0/1-10V signal, connection with 0/1-10V dimmable driver.
»  AC input, AC relay output with zero crossing detection.
» Works as RF remote control, output RF 2.4G signal, matched with RF LED controller or RF dimmable LED driver optional.
» Time delay and light threshold can be set via rotary potentiometer.

Technical parameters
Operating voltage 100-240VAC
Output signal 0/1-10V (max. 30mA), RF 2.4GHz
Output current Max. 4A (AC)
Power consumption <1,3W (operation)
detection range Max. (DxH) 10 x 5m
Holding time 10s/30s/90s/3min/10min/30min/+∞
Standby time 0s/30s/90s/3min/10min/30min/+∞
Daylight threshold 10lux/30lux/50lux/100lux/150lux/200lux/Disable
Expected light 50lux/100lux/150lux/200lux/250lux/300lux/400lux
Mounting height 5m max.
Angle of coverage 360° (ceiling installation)
Operating temperature Ta: -20°C – +50°C
IP protection class IP20
Warranty: 5 years

Note on installing the PIR sensor
1. If the sensor is exposed to direct sunlight, an interference signal is generated.
2. The sensor should be installed in a dry environment and kept away from windows, air conditioners and fans.
3. Make sure the sensor is located away from heat sources such as countertops, kitchen appliances that produce hot steam, walls and
windows exposed to direct solar irradiation, air conditioners, heaters, refrigerators, stoves, etc.
4. There should be no obstacle (screen, furniture) in the detection range.

Manual

Sys-Pro series overview

Seotud tooted