• In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.
• Built-in DALI-2 interface, DALI DT6 device
• Match all DALI systems in the market
• Manual /automatically DALI address setting
• DALI address digital indicate
• Four channels with same address
• To work with power repeater to expand output power unlimitedly.
• Waterproof grade:IP67
Setting DALI address
1.1. Press and hold down any of the two buttons until numeric digital display flashes, then release the button.
1.2. Click any of the two buttons once to select a digit, click again to change the digit until the desired DALI
address appears. Click first button to set “tens” position and second button to set “units” position. The address
can be set from 00~63.
1.3. Then press and hold down any of the 2 buttons until the numeric digital display stops flashing to confirm the
setting.
Note: DALI address can be manually assigned from 00-63-FF, by factory defaults, no DALI address is
assigned for the dimmer, and the display shows . Setting DALI address as will reset the dimmer to factory defaults.
Operation
DALI Controller
DALI
Master
Function introduction
Product Data
• DO NOT install with power applied to device.
• This device is IP67 rating and protected against damp environment.
Safety & Warnings
Important: Read All Instructions Prior to Installation
• In compliance with IEC 62386-101:2014, IEC 62386-102:2014, IEC 62386-207 Ed2.
• Built-in DALI-2 interface, DALI DT6 device
• Match all DALI systems in the market
• Manual /automatically DALI address setting
• DALI address digital indicate
• Four channels with same address
• To work with power repeater to expand output power unlimitedly.
• Waterproof grade:IP67
DALI Address Assigned by DALI Masters
DALI address can also be assigned by DALI Master controller automatically, please refer to user manuals of
compatible DALI Masters for specific operations.
Note: The digital display will show When the DALI master is assigning addresses.
Once an address is selected, all four channels’ address will be the same. For example, if the dimmer is
addressed to 22 on the display then CH1, CH2, CH3, CH4 will be the same address 22.


Voolumõõtja pistikusse max 3680W 16A
Sys-One RGB 1 zone recessed controller frameless with battery
DMX512 RDM 8/16 bit decoder, 1-5 channel, 12-36V 5x5A, 48V 5x1.5A
Automaatse sisselülituse taimer/aegrelee IP44
LED Mini PWM controller for installation under profile cover, 1 channel, 12-24V DC 3A
Sys-One Radio PWM controller, 4 channel, 12-36V 4x5A, 48V 4x2.5A
Step-By-Step trepikontroller PIR sensoritega
Sys-One RGB+W 4 zone Remote control multi-function
LED drywall-light profile Double Curve, 200cm
LED strip radio PWM controller, 1 channel, 12-24V DC 8A, follow-up control
Sys-Pro 2-Push Input, Wireless Output for Switch/Dimming/CCT/ RGB/RGB+W Receiver, 100-240V
MiniAMP uksesensor-lüliti 2m kaabliga 12-24V, max 3A, kroom/must
4 zones remote control with 3 scene memories for 4 zones PWM dimmer No. 115484
End cap EC90 aluminum black RAL 9005 for profile HIDE DOUBLE incl. screws
Wireless Touch RGB PWM controller with Radio remote control Flat, 12-24V DC 3x6A
RGB+W PWM controller with local and remote control, 2 scene memory, 4 channel, 12-36V, 4x5A
Daylight sensor passive for parallel connection into active 1-10V control signal wires
Wall lamp Up&Down 2xGX53, IP54, LxWxH 150x108x140, anthracite, excl. illuminant
Sys-One 1 zone controller with pushbutton + battery
ZigBee 3.0 PWM controller for LED flex ribbons/spots, 5 channel, 12-24V DC 5x4A
MiniAMP PIR liikumisandur 2m kaabliga 12-24V, max 5A, kroom
Sys-One wireless PWM controller IP66, 4 channel, 12-36V 4x5A, 48V 4x2A
Sys-Pro 1 zone built-in Touch-Radio operation 1x0-10V output, black, 85-265V
Sys-One RGB+W 8 zone remote control black
LED CC transformer 100/180/270/350/440mA, 10W, Push/0-10V/DALI dimmable 
























Arvustusi pole veel